Your Cart is Empty

No Wires, No Glue, No Slipping

If you ride a dirt bike, then you know what it is like to have a grip that slips. Despite all your efforts to glue and safety wire the grip in place, it usually slips. Just the process of gluing and wiring grips can be a hassle as well. The wire often breaks during installation, and once installed, there is often a sharp point that wreaks havoc on your hands. Additionally, the gluing process is a mess and it is impossible to get consistent coverage between your grip and the bar. Risk Racing created a simple and effective solution grip bonding system called Fusion.

Fusion Grip Bonding System step 1Clean the bar and begin to place bonding strip.
Fusion Grip Bonding System step 2peel and apply the bonding strips to your bars, leaving a little on the end to press into the bar.
Fusion Grip Bonding System step 3spray the bonding strips with the Fusion Spray.
Fusion Grip Bonding System step 4Easily slide your grip into place and after 10-15 minutes the grips are bonded to your bars.
Risk Racing Europe Rider Racing Fusion Grips

Risk Racing wave grip ergonomics

Wave Ergonomics

The large flange of the moto grip has a slight bend to it. This bend reduces pressure points between the riders’ thumb and the grip flange, preventing blisters on the side of your thumb.

Gripping Ribs

The Moto grip features three minimal, but meaningful, ribs on the bottom side of the grip. These three ribs interact with your last two fingers, which provide most of the gripping power in your hand.

Fusion Moto Grips ribs
Risk Racing Fusion Grips ends

Dual Compound

Premium, dual compound grip that feature great vibration damping and durability.The ends of these grips are double walled reinforced to prevent damage during tip overs.

Fusion Bonding System

Fusion Grips include the Fusion Bonding System kit. At first the Fusion Spray acts as a lubricant for easy grip installation, but after it dries, it creates a lasting bond. The entire process is clean and simple, and bonds in about 10-15 minutes. Removal of the grips is the same process as any other grip.

Fusion Bonding System


Ergonomic "Wave" Flange

Two finger gripping ribs

Dual compound micro texture

Double walled grip end protection

Fusion bonding system for fast no slip installation

What's Included

Risk Racing Fusion Grip
Moto/ATV Grip Pair

choice of MOTO, ATV/MTB

Fusion Bonding Strips and Catalyst Spray
Fusion Bonding System
2x bonding strips, 1x catalyst spray bottle

Choose Your Grip

MOTO 2.0
Fusion 2.0 Moto GripShop
Fusion 2.0 ATV/MTB GripShop

  • Dual rubber compound
  • Rubber ends
  • Ergo Wave Flange on Moto version

MOTO 2.0
Red: 00284
Blue: 00285
Green: 00286
Orange: 00287
Yellow: 00288

Red: 00289
Blue: 00290
Green: 00291
Orange: 00292
Yellow: 00293

Installing Fusion Grips

California Prop. 65 WARNING:
This product can expose you to Bisphenol A, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.